Filter
Top Products
MAINTENANCE
2.12
Specified Lubricant:
AGL Gearcase Lubricant:
(PN 2873603) (Gallon) (PN 2873602) (12 oz.)
Capacity: At change: Approx. 32 oz.....
(948 ml)
Drain Plug & Fill Plug:
22 ft. lbs. (30 Nm)
TRANSMISSION SPECIFICATIONS
To check the level:
1. Remove fill plug.
2. Fluid should be filled to bottom of fill plug hole
threads. Add the proper lubricant as required to
bring level into operating range as shown.
Oil Fill Plug
Oil Fill Level--
Bottom Fill Plug
Hole Threads
AGL
To change lubricant:
1. Place a drain pan beneath the transmission oil
drain plug area.
S Elevate the front of the machine
using a proper lifting device or
automotive approved ramps.
S This will ensure that the oil in the
transmission is properly drained.
2. Remove the drain plug and wipe the magnetic end
clean to remove accumulated metallic filings.
3. After the oil has drained completely, install a new
sealing washer (if installed) and install the drain
plug. Torque to 22 ft.lbs. (30 Nm).
4. Add the proper lubricant through the fill plug hole
until the oil level is to the bottom of the fill plug hole
threads (See Illustration above). Do not overfill.
5. Check for leaks.
6. Reinstall skid plate if removed in Step 1.
LUBRICATIONS / GREASE
POINTS
As shown on Page 2.7, there are 3 grease zerks on
the Sportsman, two front ball joints and front prop
shaft.
Ball Joint Zerk