Filter
Top Products
TRANSMISSION
8.16
8. Once the gear backlash is found, to install the
snorkel lock screw, you may have to rotate the
snorkel tube clockwise or counterclockwise
slightly. This will allow the snorkel lock screw to
thread itself into one of the slots of the snorkel
tube (See illustration below) to secure the snorkel
tube.
Screw Fits in Slots of Snorkel Tube
8--12 ft.lbs.
9. With the snorkel shaft assembly in place, remove
the 4 Torx screws from the output shaft assembly.
Remove the output shaft assembly.
Remove Screws Output Shaft Assy.
10. Assemble the input shaft assembly if previously
disassembled.
Input Shaft AssemblyA. Ball Bearing
B. Input Shaft
C. Silent Chain
A
A
B
C
11. Assemble the reverse shaft assembly if
previously disassembled.
A. Ball Bearing
B. Engagement Dog
C. Retaining Ring
D. Washer
E. 33T Gear
F. Needle Bearing
G. Reverse Shaft
H. Needle Bearing
I. 24T Sprocket
Towards Inside
of Case
J. Washer
K. Retaining Ring
L. Engagement Dog
M. Washer
N Needle Bearing
O. 28T Gear
P. Washer
Q. Retaining Ring
R. Ball Bearing
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
REVERSE SHAFT