Filter
Top Products
ELECTRICAL
10.34
the life of the lamp.
1
4. Install the new headlamp and harness assembly
into the headlight assembly.
HEADLAMP SWITCH
Remove the headlight pod cover. Probe the
headlamp plug wires (Brown and Yellow) at back of
connector. Turn headlight on.
Upper Headlamp Plug Wires
Brown
Yellow
Brown
Green
Lower Headlamp(s) Plug Wires
BRAKE LIGHT / WORK LIGHT
REPLACEMENT
The brake light (A) and the work light (B) are both
located in the rear tail lamp housing.
A
B
1. To remove the worklight electrical connector (B),
pull down on the connector lock and pull the
connector from the bulb assembly.
B
2. Toremove thebrake lightelectrical connector (B),
press in on the tab on the connector to unlock the
connector and pull the connector from the bulb
assembly.
A
3. To remove either of the bulbs, turn the bulb
counter--clockwise to remove and pull out. Turn
the bulb clockwise to install. Refer to the parts
manual for the correct bulb part number.
Remove
Install
WORKLIGHT SWITCH
Remove the headlight pod cover to locate the switch
wires. The switch simply snaps out by pushing in on
the tabs on both sides of the switch.