Filter
Top Products
Reference Manual
00809-0100-4832, Rev AA
October 2004
Rosemount 3095FC
www.rosemount.com
Section 3 Configuration
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-1
Basic Functions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-1
Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-4
Custom Displays . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 3-54
OVERVIEW The Rosemount 3095FC has parameters that must be configured before it is
calibrated and placed into operation. Configuration must be performed using
Rosemount User Interface Software. Configuration can be performed either
onsite using the LOI port or off-line and later loaded into the unit.
Default values for all parameters exist in the firmware of the 3095FC. The
following parameters should be verified and configured:
• “Setting the Clock” on page 3-4
• “Configuring the System Flags” on page 3-5
• “3095FC Communications Ports Configuration” on page 3-8
• “Security Configuration” on page 3-13
• “LCD User List Configuration” on page 3-15
• “Analog Input (AI) Configuration” on page 3-16
• “Meter Run Configuration” on page 3-25 and “Gas Quality Tab” on
page 3-28.
• “History Points Configuration” on page 3-32
BASIC FUNCTIONS Begin the configuration process with “Setting the Clock” on page 3-4.
The following functions are used throughout the configuration process. They
are provided at the beginning of the section so they can be easily referenced.
Select TLP Options
Throughout Rosemount User Interface Software, the Select TLP dialog can
be accessed by clicking the browse button with three dots. The Select TLP
dialog allows the user to assign specific inputs and outputs to parameters.
Rosemount User Interface Software uses Point Type (T), Logical Number (L),
and Parameter (P) to define point locations.
The display field at the bottom of the Select TLP dialog displays the numeric
point location of the TLP point or a text abbreviation, depending on the
Display setting (see “Display TLP Options").
Display TLP Options
Select Tools > Options to set whether the TLP displays as text or numbers in
TLP display fields throughout the Rosemount User Interface Software.