Filter
Top Products
Reference Manual
00809-0100-4832, Rev AA
October 2004
2-14
Rosemount 3095FC
Connect
When off-line, the 3095FC menu displays Connect. To use Connect:
1. Physically connect the 3095FC (see “Installation” on page 2-2).
2. Launch and log into Rosemount User Interface Software (see
“Getting Started with the Software” on page 2-12).
3. Perform one of the following:
• Select a communications port from the Device Directory and press
the <Enter> key.
• Double-click on a communications port from the Device Directory.
• Click the Connect button on the toolbar.
• Select Device > Connect to connect to the 3095FC currently
selected in the Device Directory. If a 3095FC is not currently
selected, the error “No 3095FC is Currently Selected” appears.
Remote Hardware Connection
To connect the PC to a remote 3095FC, a serial, dial-up modem, radio,
satellite, or other communications line should be installed. This connection is
typically made through the host port on the 3095FC. Use the Connect
command to connect to a serial or dial-up modem
Disconnect from the 3095FC
Close the screen to disconnect an on-line connection. This automatically
closes the connection.
CONFIGURATION TREE When communication is established with a 3095FC or opening a
configuration file, the Configuration Tree appears on the screen. The
Configuration Tree is used to perform the following:
• Add, delete, or modify communication configurations for the 3095FC
units. The communication configurations allow the Rosemount User
Interface Software to communicate to an individual 3095FC unit.
• Establish Groups of 3095FC units. A 3095FC Group is typically several
units in the same geographical area or a number of units with
something else in common. Each group contains a list of all the
3095FC devices contained within that group.
• Assign an address for every 3095FC within a group. Each 3095FC has
a Station Name (Tag) and unique address with which to differentiate
each device. The Address must be different from any other host system
that may access the communications link.
• Setup the 3095FC Comm Ports
Use the “+” and “–” symbols to display or hide various options.
Toggle between the Online configuration screen and the Configuration
tree/device directory using Window > >select file>.