1-6
Rosemount 3095FC
Reference Manual
00809-0100-4832, Rev AA
October 2004
NOTE:
Do not allow the batteries to fully discharge. If the batteries fully discharge, the
battery charger board may enter thermal limiting.
Rosemount User
Interface Software PC
Requirements
The Rosemount User Interface Software operates on any PC that meets the
following requirements:
• IBM compatible
• Pentium-Class Processor (233 MHz or greater is recommended)
• CD-ROM drive
• Windows 95 (service release B), 98, ME, NT 4.0 (Service Pack 6),
2000 (Service Pack 2), or XP.
•32 MB RAM
• 10 MB of available hard disk space
• RS-232 serial communication
• SVGA color monitor, 800 x 600 pixels
Site Requirements Local, state, and federal codes may restrict monitoring locations and dictate
site requirements. Position the 3095FC to minimize the length of signal and
power wiring.
Wiring Requirements I/O wiring requirements are site and application dependent. Local, state, or
NEC requirements determine the I/O wiring installation methods. Direct burial
cable, conduit and cable, or overhead cables are options for I/O wiring
installations.