Filter
Top Products
Reference Manual
00809-0100-4832, Rev AA
October 2004
2-10
Rosemount 3095FC
APPLY POWER To prevent unnecessary battery drainage, the 3095FC is delivered with the
reset jumper in the OFF position. To apply power to the 3095FC:
1. Complete the necessary wiring (“Wiring” on page 2-4).
1. Unscrew the front end cap cover (LCD end).
2. Place the power jumper in the ON position. The jumper is located on
the LCD (if installed) or at J1 on the Battery Charger Board.
3. Screw the front-end cap cover (LCD end).
After the 3095FC completes start-up diagnostics (RAM and other internal
checks), the optional LCD displays the date and time to indicate that the
3095FC completed a valid reset sequence. If the LCD does not come on,
refer to Section 5: Troubleshooting and Maintenance.