Filter
Top Products
Reference Manual
00809-0100-4832, Rev AA
October 2004
A-11
Rosemount 3095FC
OPTIONS
Standard Configuration Unless otherwise specified, the transmitter is shipped as follows:
Custom Configuration
(Option Code C1)
If Option Code C1 is ordered, the user-specified information for the 3095F
Modbus Transmitter in addition to the standard configuration parameters are
factory configured.
Message, descriptor, slave address, baud rate, upper and lower trim points for
each process variable, damping for each process variable, units for each
process variable, upper and lower operation limits. Unspecified parameters
will remain at the factory default settings.
Tagging
Three customer tagging options are available:
• Standard SST tag is wired to the transmitter. Tag character height is 0.125
in. (3,18 mm),
85 characters maximum.
• Tag may be permanently stamped on transmitter nameplate upon request.
Tag character height is 0.0625 in. (1,59 mm),
65 characters maximum.
• Tag may be stored in transmitter memory. Software tag is left blank unless
specified.
• Software tag is left blank unless specified.
Optional 305 Integral Manifolds
The Rosemount 3095FC Transmitter with 305RC (or 305AC, 305BC) Integral
Manifold are fully assembled, calibrated, and seal tested by the factory. Refer
to PDS 00813-0100-4733 for additional information.
ACCESSORIES Rosemount User Interface Software Packages
The Rosemount User Interface Software package is available with or without
the converter and connecting cables. All configurations are packaged
separately.
Windows 98 or higher
3095FC
• Part Number 03095-5136-0001: Windows User Interface Software–Single
PC License, and Cable.
• Part Number 03095-5135-0001: Windows User Interface Software–Single
PC License.
• Part Number 03095-5135-0002: Windows User Interface Software– Site
License.
• Part Number 03095-5106-0003: 10 foot (3.05 m) 9-pin Serial Cable
Engineering units:
Differential inH
2
O
Absolute/gage psi (all ranges)
Output: Modbus RTU protocol signal
Flange type: Specified model code option
Flange material: Specified model code option
O-ring material: Specified model code option
Drain/vent: Specified model code option
Flow Configuration Parameters: Factory default
Software tag: (Blank)