Filter
Top Products
3 - 42
INSP
ADJ
FUSE INSPECTION/HEADLIGHT BEAM ADJUSTMENT/
HEADLIGHT BULB REPLACEMENT
4.Replace:
● Blown fuse
**********************************
Blown fuse replacement steps:
●Turn off ignition and the circuit.
●Install a new fuse of proper amperage.
●Turn on the switches and see if the electri-
cal device operates.
●Fuse interrupts the circuit again’ Check
electrical system.
Refer to “CHAPTER 8. ELECTRICAL” for
further information.
**********************************
5.Install:
● Fuse cover
● Seat
Refer to the “REAR FENDER-Installation”
section.
HEADLIGHT BEAM ADJUSTMENT
1.Adjust:
● Headlight beam (vertically)
Vertical adjustment
Higher
Turn the adjusting screw
1 clockwise.
Lower
Turn the adjusting screw
1 counterclockwise.
HEADLIGHT BULB REPLACEMENT
1.Disconnect:
● Headlight lead couplers 1
2.Remove:
● Headlight unit 2
3.Pull back the bulb cover 1.
4.Remove:
● Bulb holder 2
While pushing the bulb holder 2, turn it
counterclockwise.
NOTE:
Hold the head light on the front side while
removing the bulb socket.
3