Filter
Top Products
6 - 41
DRIV
FINAL DRIVE GEAR AND DRIVE SHAFT
4.Install:
● Final gear case unit 1
NOTE:
Before installing the final gear case unit,
apply the grease to the O-ring 2.
5.Connect:
● Breather hose 5 (final gear case)
CAUTION:
Make sure the final gear case breather hose
is routed correctly.
6.Install:
● Rear axle
● Final gear case protector
● Brake drum
● Rear wheel (right)
● Wheel hub
● Rear wheel (left)
Refer to the “REAR WHEEL/REAR BRAKE
AND REAR AXLE - Installation” section in
CHAPTER 7.
7.Fill:
● Final gear case
Refer to the “FINAL GEAR OIL PEPLACE-
MENT” section in CHAPTER 3.
8.Install:
● Rear fender
● Seat
● Rear carrier
Refer to the “FENDERS AND FUEL TANK-
REAR FENDER-Installation” section in
CHAPTER 3.
T
R
.
.
Bolt (final gear case – axle hous-
ing) 3:
55 Nm (5.5 m • kg, 40 ft • lb)
Nut (final gear case – swingarm)
4:
48 Nm (4.8 m • kg, 35 ft • lb)
Recommended oil:
SAE 80 API “GL-4” hypoid gear
oil
If desired, and SAE 80W90
hypoid gear oil may be used
for all condition.
Oil quantity:
0.27 L (0.24 Imp qt, 0.29 US qt)
6