Filter
Top Products
8 - 14
–+
ELEC
ELECTRIC STARTING SYSTEM
EB803020
TROUBLESHOOTING
IF THE STARTER MOTOR FAILS TO OPERATE:
Procedure
Check:
1.Fuse (main)
2.Battery
3.Starter motor
4.Starting circuit cut-off relay
5.Starter relay
6.Main switch
7.Neutral switch
8.Rear brake lever switch
9.Start switch
10.Wiring connection
(the entire starting system)
NOTE:
● Remove the following part(s) before trou-
bleshooting:
1)Seat
2)Front carrier
3)Front fender
● Use the following special tool(s) for trou-
bleshooting.
Pocket tester:
P/N. YU-03112, 90890-03112
EB802011
CONTINUITY
1.Fuse (main)
Refer to “SWITCH INSPECTION”.
NO CONTINUITY
Replace the fuse.
EB802012
CORRECT
2.Battery
● Check the battery condition.
Refer to “BATTERY INSPECTION” in
CHAPTER 3.
Open-circuit voltage:
12.8 V or more at 20 ˚C (68 ˚F)
*
INCORRECT
● Clean the battery terminals.
● Recharge or replace the battery.
8