Filter
Top Products
4 - 4
ENG
ENGINE REMOVAL
REAR WHEEL DRIVE ASSEMBLY AND
SWINGARM
1.Disconnect:
● Breather hose 1 (final gear housing and
rear brake drum)
(from the cable guides 2 of main frame)
2.Block the front wheels, and elevate the
rear wheels by placing the suitable stand
under the frame.
3.Remove:
● Bolt 1 (rear shock absorber-top)
4.Remove:
● Clamps 1 (rubber boot)
● Pivot shaft caps 2
● Locknuts 3 (pivot shaft)
● Pivot shafts 4 (swingarm)
5.Remove:
● Rear wheel drive assembly/swingarm
CAUTION:
● When removing the swingarm, hold the
shock absorber so that it may not fall over.
● When the swingarm is disconnected from
the rubber boot, the drive shaft may fall
off. Be careful not to lose these parts.
ENGINE REMOVAL
1.Remove:
● Bolts 1 (engine mounting - top)
● Bolt 2 (engine mounting - front)
● Bolt 3 (engine mounting - rear upper)
● Bolt 4 (engine mounting - rear lower)
2.Remove:
● Engine assembly (to right side)
4