Filter
Top Products
– 25 –
CHAS
FRONT BRAKE
5.Remove:
● Brake pads 1
(with pad shim 2)
● Pad spring 3
N
OTE:
● When pad replacement is required, also
replace the pad spring and shim.
● Replace the pads as a set if either is found to
be worn to the wear limit a.
Wear limit a:
1.0 mm (0.04 in)
1
2
3
6.Install:
● Pad shim
(onto inside brake pad)
● Pad spring
● Brake pads
*********************************************
Installation steps:
●Connect a suitable hose 1 tightly to the cali-
per bleed screw 2. Then, place the other
end of this hose into an open container.
●Loosen the caliper bleed screw and push the
pistons into the caliper with the finger.
●Tighten the caliper bleed screw 2.
●Install the pad shim 3 (new) onto the brake
pad (new).
N
OTE:
The arrow mark a on the pad shim must point
in the direction of the disc rotation.
●Install the pad spring (new) and brake pads
(new).
*********************************************
T
R
.
.
Caliper bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)