7 - 25
CHAS
STEERING SYSTEM
2.Lubricate:
● Steering bearings 1
● Oil seals 2
Lithium-soap base grease
3.Install:
● Oil seals 1 (to steering shaft)
● Collars 2
● Steering bearings 3
NOTE:
Be careful not to damage the oil seals dur-
ing installation.
4.Install:
● Steering shaft 1 (with steering bearings)
WARNING
Make sure the brake cables and leads are
properly routed, and are not damaged or
twisted.
5.Install:
● Tie-rods (left and right)
NOTE:
Be sure that the rod-end 1 on the indenta-
tion 2 side is connected to the knuckle arm.
6.Tighten:
● Nuts 1 (tie-rod end)
T
R
.
.
Nut (tie-rod):
25 Nm (2.5 m • kg, 18 ft • lb)
7