Filter
Top Products
3 - 29
INSP
ADJ
DRIVE SELECT LEVER POSITION ADJUSTMENT/
FINAL DRIVE GEAR OIL LEVEL INSPECTION
DRIVE SELECT LEVER POSITION
ADJUSTMENT
1.Adjust:
● Drive select lever position
**********************************
Adjustment steps:
●Place the machine on a level place.
●Shift the transmission in first gear, and
move the select lever 1 to reverse posi-
tion.
●Loosen the locknuts 2.
●Turn the select lever adjuster 3 in or out
until lever 4 center line a aligns with
match mark b on the crankcase cover.
●Tighten the locknuts 2.
NOTE:
After adjusting the drive select lever, be
sure the reverse indicator light comes on
when the drive select lever is in reverse
position.
**********************************
T
R
.
.
Locknut (select lever adjuster):
15 Nm (1.5 m • kg, 11 ft • lb)
FINAL DRIVE GEAR OIL LEVEL INSPECTION
1.Inspect:
● Final drive gear oil level
Oil level low → Add sufficient oil.
NOTE:
The engine should be cool (at atmospheric
temperature).
**********************************
Inspection steps:
●Place the machine on a level place.
●Place an oil pan under the final drive gear
case.
●Remove the filler bolt 1 and copper
washer.
●Visually check the oil level. Correct oil
level should be at the lower brim of the
hole.
3