Filter
Top Products
6 - 37
DRIV
FINAL DRIVE GEAR AND DRIVE SHAFT
2.Install:
● Thrust washer 1
● Ring gear 2
● Shim(s) 3 (proper size as calculated)
● Bearing housing 4
NOTE:
● Before installing the ring gear, apply the
grease to the oil seal rips.
● Before installing the bearing housing,
apply the grease to the O-ring.
3.Install:
● 10 mm bolts 1 (bearing housing)
● 8 mm bolts 2 (bearing housing)
NOTE:
Tighten the bolts in stage, using a criss-
cross pattern.
T
R
.
.
10 mm Bolts (bearing housing):
40 Nm (4.0 m • kg, 29 ft • lb)
8 mm Bolts (bearing housing):
23 Nm (2.3 m • kg, 17 ft • lb)
FINAL GEAR GEAR LASH MEASUREMENT
AND ADJUSTMENT
Final gear gear lash measurement
1.Secure the gear case in a vise or other
support.
2.Remove:
● Drain plug
● Gasket
3.Install:
● A bolt of the specified size 1
Into the drain plug hole.
CAUTION:
Finger tighten the bolt until it holds the
ring gear. Otherwise, the ring gear will be
damage.
6