Filter
Top Products
4 - 45
ENG
ENGINE ASSEMBLY AND ADJUSTMENT
ENGINE ASSEMBLY AND
ADJUSTMENT
RECOIL STARTER
1.Install:
● Starter spring 1
NOTE:
Mesh the spring hook 2 wise the case slit,
then carefully wind the spring counterclock-
wise, and fit the spring into the case.
2.Install:
● Plate 1
● Starter spring case 2
NOTE:
Mesh the end 3 of the sheave spring with
spring hook 4 on the recoil starter cover.
3.Wind the rope 4-1/2 turns clockwise
around the sheave drum, and set the rope
onto the drum slit.
4.Lubricate:
● Starter spring
● Sheave drum
5.Install:
● Sheave drum 1
NOTE:
Make sure the two slots 2 are meshed into
the two projections 3 respectively.
Also, make sure slot 4 properly fits over
the spring end 5.
Lithium-soap base grease
4