Filter
Top Products
6 - 33
DRIV
FINAL DRIVE GEAR AND DRIVE SHAFT
Example:
1) If the “+01” is stamped on the final
drive pinion gear,
a = 79 + 0.01 = 79.01
2) If the “50” is stamped on the final gear
case,
b = 78 + 0.50 = 78.50
3) Therefore, “A” is,
“A” = 79.01 – 78.50 = 0.51 mm
4) Round off hundredths digit and select
appropriate shim(s).
In the example above, the calculated
number is 0.51. The chart instructs you
to round off 1 to 0 at the hundredth
place.
Thus, the shim thickness is 0.50 mm.
Shim sizes are supplied in the following
thickness.
*********************************
Hundredths Round value
0, 1, 2 0
3, 4, 5, 6, 7 5
8, 9 10
Final drive pinion
gear shim
Thickness (mm)
0.15 0.50
0.30 0.60
0.40
Ring gear shim(s) selection
1.Select:
● Ring gear shim(s) 1
6