Filter
Top Products
4 - 57
ENG
ENGINE ASSEMBLY AND ADJUSTMENT
PRIMARY AND SECONDARY CLUTCHES
1.Install:
● Clutch housing 1 (secondary)
● Washer 2
2.Install:
● Friction plates 1
● Clutch plates 2
(to clutch boss 3)
NOTE:
Install the clutch plates and friction plates
alternately on the clutch boss, starting with
a friction plate and ending with a friction
plate.
3.Install:
● Clutch boss 1
● (to pressure plate assembly 2)
NOTE:
Align the arrow marks 3 on the clutch boss
with the arrow mark 4 on the pressure
plate.
4.Install:
● Secondary clutch assembly 1
● (to main axle 2)
● Lock washer 3
● Nut 4 (clutch boss)
WARNING
Always use a new lock washer.
NOTE:
Make sure that the tabs of the lock washer
engages the indentations in the clutch boss.
5.Tighten:
● Nut 1 (clutch boss)
T
R
.
.
Nut (clutch boss):
50 Nm (5.0 m • kg, 36 ft • lb)
4