Filter
Top Products
7 - 24
CHAS
STEERING SYSTEM
6.Adjust:
● Tie-rod assembly length
*********************************
Tie-rod assembly length adjustment steps:
●Loosen the locknuts.
●Adjust the tie-rod assembly length a by
turning both tie-rod ends.
Å Right-hand-threads
ı Left-hand-threads
Ç To steering shaft
Î To knuckle
NOTE:
The threads b on both tie-rod ends must be
of the same length.
●Tighten the locknuts.
*********************************
Tie-rod assembly length a:
296 mm (11.7 in)
T
R
.
.
Locknut (tie-rod):
30 Nm (3.0 m • kg, 22 ft • lb)
7.Inspect:
● Bushings 1 (steering shaft lower)
● O-rings 2
Wear/Damage → Replace.
INSTALLATION
Reverse the “REMOVAL” procedures.
Note the following points.
Steering shaft
1.Lubricate:
● Busings 1 (steering shaft lower)
● O-rings 2
Lithium-soap base grease
7