Filter
Top Products
8 - 22
–+
ELEC
CHARGING SYSTEM
EB804010
TROUBLESHOOTING
IF THE BATTERY IS NOT CHARGED:
Procedure
Check:
1.Fuse (main)
2.Battery
3.Charging voltage
4.Stator coil resistance
5.Wiring connections
(the entire charging system)
NOTE:
● Remove the following part(s) before trou-
bleshooting:
1)Seat
● Use the following special tool(s) for trou-
bleshooting.
Inductive tachometer:
P/N. YU-8036-A
Engine tachometer:
P/N. 90890-03113
Pocket tester:
P/N. YU-03112, 90890-03112
EB802011
CONTINUITY
1.Fuse (main)
Refer to “SWITCH INSPECTION”.
NO CONTINUITY
Replace the fuse.
EB802012
CORRECT
2.Battery
● Check the battery condition.
Refer to “BATTERY INSPECTION” in
CHAPTER 3.
Open-circuit voltage:
12.8 V or more at 20 ˚C (68 ˚F)
INCORRECT
● Clean the battery terminals.
● Recharge or replace the battery.
EB804011
3.Charging voltage
● Connect the engine tachometer to the
spark plug lead.
● Connect the pocket tester (DC 20V) to
the battery.
Tester (+) lead → Battery (+) terminal
Tester (–) lead → Battery (–) terminal
8