Filter
Top Products
– 15 –
– +
ELEC
CHECKING THE SWITCH
ELECTRICAL
CHECKING THE SWITCH
CHECKING THE SWITCH
Use a pocket tester to check the terminals for
continuity. If the continuity is faulty at any
point, replace the switch.
N
OTE:
●
Set the pocket tester to “0” before starting
the test.
●
The pocket tester should be set to the
“
Ω ×
1”
range when testing the switch for continuity.
●
Turn the switch on and off a few times when
checking it.
Pocket tester:
P/N. YU-03112, 90890-03112
CHECKING A SWITCH SHOWN IN THE
MANUAL
The terminal connections for switches (main
switch, handlebar switch, engine stop switch,
light switch, etc.) are shown in a chart similar
to the one on the left.
This chart shows the switch positions in the
column and the switch lead colors in the top
row.
For each switch position, “” indicates
the terminals with continuity.
The example chart shows that:
1
There is continuity between the “Red and
Brown” leads when the switch is set to “ON”.