Filter
Top Products
7 - 27
CHAS
STEERING SYSTEM
Handlebar
1.Install:
● Handlebar holder (lower) 1
● Handlebar 2
● Handlebar holders (upper) 3
NOTE:
The upper handlebar holder should be
installed with the punched mark a forward
2.
CAUTION:
Tighten the handlebar bolts so that clear-
ances b are spaced evenly.
T
R
.
.
Handlebar holder (upper):
20 Nm (2.0 m • kg, 14 ft • lb)
2.Install:
● Throttle lever assembly
NOTE:
Fit the throttle housing projection 1 onto
the indent 2 on the front brake lever
holder.
WARNING
Proper cable and lead routing is essential
to assure safe machine operation. Refer to
the “CABLE ROUTING” section in CHAP-
TER 2.
3.Adjust:
● Brake cable free play
Refer to the “FRONT BRAKE ADJUST-
MENT” and “REAR BRAKE LEVER AND
PEDAL ADJUSTMENT” section in CHAP-
TER 3.
4.Adjust:
● Toe-in
Refer to the “TOE-IN ADJUSTMENT” sec-
tion in CHAPTER 3.
5.Install:
● Front fender
● Front bumper
● Front carrier (except for USA)
Refer to the “FENDERS AND FUEL TANK
—FRONT FENDER-Installation” section in
CHAPTER 3.
7