Filter
Top Products
1 - 3
GEN
INFO
EB101030
LOCK WASHERS/PLATES AND COTTER
PINS
1.Replace all lock washers/plates
1
and cot-
ter pins after removal. Bend lock tabs
along the bolt or nut flats after the bolt or
nut has been tightened to specification.
IMPORTANT INFORMATION
EB101040
BEARINGS AND OIL SEALS
1.Install bearings and oil seals so that the
manufacturer’s marks or numbers are vis-
ible. When installing oil seals, apply a
light coating of lightweight lithium base
grease to the seal lips. Oil bearings liber-
ally when installing, if appropriate.
1
Oil seal
CAUTION:
Do not use compressed air to spin the bear-
ings dry. This will damage the bearing sur-
faces.
1
Bearing
EB101050
CIRCLIPS
1.Check all circlips carefully before reas-
sembly. Always replace piston pin clips
after one use. Replace distorted circlips.
When installing a circlip
1
, make sure
that the sharp-edged corner
2
is posi-
tioned opposite the thrust
3
it receives.
See sectional view.
4
Shaft
1