Filter
Top Products
– 49 –
–+
ELEC
ELECTRIC STARTING SYSTEM
EB803020
TROUBLESHOOTING
IF THE STARTER MOTOR FAILS TO OPERATE:
Procedure
Check:
1.Fuse
2.Battery
3.Starter motor
4.Starting circuit cut-off relay
5.Starter relay
6.Main switch
7.Engine stop switch
8.Neutral switch
9.Rear brake lever switch
10.Start switch
11.Wiring connection
(the entire starting system)
NOTE:
●
Remove the following part(s) before trouble-
shooting:
1)Seat
2)Front carrier
3)Front fender
●
Use the following special tool(s) for trouble-
shooting.
Pocket tester:
P/N. YU-03112, 90890-03112
EB802011
CONTINUITY
1.Fuse
Refer to “SWITCH INSPECTION”.
NO CONTINUITY
Replace the fuse.
EB802012
CORRECT
2.Battery
●
Check the battery condition.
Refer to “BATTERY INSPECTION”.
Open-circuit voltage:
12.8 V or more at 20 ˚C (68 ˚F)
*
INCORRECT
●
Clean the battery terminals.
●
Recharge or replace the battery.