4 - 12
ENG
ENGINE DISASSEMBLY
5.Remove:
● Lock washer 1
● Clutch carrier assembly 2
● Washer 3
● Clutch housing 4 (primary)
● Washer 5
NOTE:
The secondary clutch housing has two
grooves 1 machined into it to permit the
primary drive gear behind the primary
clutch to clear the secondary clutch. Align
one of these grooves with the primary gear
2 before removing the primary clutch
assembly.
6.Flatten:
● Nut tab 1 (drive pinion gear)
7.Remove:
● Nut 2 (drive pinion gear)
● Drive pinion gear 3
NOTE:
● Hold the clutch boss 4 on the secondary
clutch by the Rotor Holder 5 to loosen the
nut (driven pinion gear)
● Put the engine in 1st, and carry out the
operation.
8.Remove:
● Push rod 1
● Bearing 2
● Bearing holder 3
● Clutch springs 4
Rotor holder:
P/N. YU-01235, 90890-01235
4