Filter
Top Products
5. OPERATION
5-1
1
2
3
4
5
6
7
8
5. OPERATION
This chapter gives the basic operation methods of the drive unit.
CAUTION
If the machine should become out of control, perform test operation after ensuring
safety.
Start operation after performing test operation under light load at low speed to
ensure that operation is performed safely.
Check that the machine has no damage.
Securely set the parameter values to match the operating machine system
environment.
Contents of This Chapter
Page
5.1 Power On 5-2
5.2 Parameter Setting 5-2
5.2.1 Setting of the operation mode parameter........................................... 5-2
5.2.2 Confirmation of the basic operation parameters................................. 5-2
5.3 Operation Examples 5-3
5.3.1 PU operation mode............................................................................ 5-3
5.3.2 External operation mode.................................................................... 5-4
5.3.3 External/PU combined operation mode 1........................................... 5-5
5.3.4 External/PU combined operation mode 2........................................... 5-6
5.3.5 Starting operation .............................................................................. 5-7