Filter
Top Products
8 PARAMETER FUNCTIONS
8-35
8
8.6.2 Communication operation from the PU connector
Initial value
Pr. 117 "station number" 0
Pr. 118 "communication speed" 192
Pr. 119 "stop bit length/data length" 1
Pr. 120 "parity check presence/absence" 2
Pr. 121 "number of communication retries" 1
Pr. 122 "communication check time interval" 0
Pr. 123 "waiting time setting" 9999
Pr. 124 "CR-LF presence/absence selection" 1
Make settings necessary for performing RS-485 communication operation from the PU connector
using a personal computer or similar equipment.
After you have made parameter settings, reset the CPU or switch power "OFF" once. Switching
power on again makes the parameter values valid.
Pr. Setting Range Unit Description
117 0 to 31 Station Set the station number of the drive unit.
48
4800bps
96
9600bps118
192
19200bps
0
Stop bit length 1 bit/data length 8 bits
1
Stop bit length 2 bits/data length 8 bits
10
Stop bit length 1 bit/data length 7 bits
119
11
Stop bit length 2 bits/data length 7 bits
0
None
1
Odd parity present120
2
Even parity present
0 to 10 Times
Set the number of retries to be made at occurrence of a data
receive error. If errors in excess of the setting occur consecutively,
E. PUE appears, resulting in an alarm stop.
121
9999
Assigning the LF signal to the control circuit output terminal allows
a communication error occurrence signal to be output. Occurrence
of a communication error will not cause an alarm stop.
0
No communication. (Communication operation not performed)
0.01 to 999.8 s
When a no-communication status time reaches the setting,
E. PUE appears and an alarm stop occurs.
122
9999 No-communication status time check is not made.
0 to 150
Set the waiting time from when the drive unit has received data until
it gives a reply. The actual waiting time is (setting
×
10 + 12)ms.
123
9999
Set the waiting time using communication data.
0
Without CR (carriage return), LF (line feed)
1
With CR (carriage return)124
2
With CR (carriage return)/LF (line feed)