Filter
Top Products
8 PARAMETER FUNCTIONS
8-23
8
Initial value
Pr. 188 "RES terminal operation selection" 0
Select the reset operation of the RES terminal. Reset operation is performed when RES-SD (sink
logic) are shorted more than 0.1s.
Setting Name Function
0 CPU reset
The cumulative thermal value of the electronic overcurrent protection
and the retry count [Section 6.1.1] stored during operation are
initialized. The alarm status is canceled. Performing reset operation
during operation coasts the motor, and canceling the reset restarts the
motor.
1
Alarm/
CPU reset
The alarm status is canceled. At this time, the cumulative thermal value
of the electronic overcurrent protection and the retry count are also
initialized.
A reset input is not accepted during normal operation.
MEMO
The reset operation performed using the
STOP/RESET
key of the operation panel
or FR-PU04 parameter unit will result in an alarm reset regardless of the Pr. 188
setting.
The Pr. 188 setting does not return to the initial value if parameter clear or all clear
[Section 4.3] is performed.
Initial value
Pr. 189 "STF, STR terminal operation selection" 0
You can turn the terminal STF into a start/stop function and the terminal STR into a direction of
rotation direction switching function.
Forward Rotation
Operation
Reverse Rotation
Operation
Stop
Setting
STFSTRSTFSTRSTFSTR
OFF OFF
0ONOFFOFFON
ON ON
OFF OFF
1 ON OFF ON ON
OFF ON