Chrysler 2007 300 SRT8 Automobile User Manual


 
Center (EVIC) will display a ЉCHECK TPM SYSTEMЉ
message for 3 seconds when a system fault is detected. In
the event that a fault occurs because the system did not
receive a pressure value from one or more Tire Pressure
Monitoring Sensors, the EVIC will display the ЉCHECK
TPM SYSTEMЉ message and then display dashes (- -) in
place of the pressure value to indicate which sensor is not
being received.
NOTE:
You can change the pressure units to display in
PSI, kPA, or BAR. Refer to “Language,” under “Personal
Settings (Customer Programmable Features),” under
“Electronic Vehicle Information Center (EVIC)” in Sec-
tion 4 of this manual for details.
If the ignition key is cycled, this sequence will repeat,
providing the system fault still exists. If the system fault
no longer exists, the Tire Pressure Monitoring Telltale
Light will no longer flash, and the ЉCHECK TPM SYS-
TEMЉ message will no longer display, and a pressure
value will display in place of the dashes.
General Information
This device complies with part 15 of the FCC rules and
RSS 210 of Industry Canada. Operation is subject to the
following conditions:
This device may not cause harmful interference.
This device must accept any interference received,
including interference that may cause undesired op-
eration.
STARTING AND OPERATING 245
5