Filter
Top Products
3 - 37
CHK
ADJ
ADJUSTING THE REAR BRAKE
●
Turn the brake lever cable adjusting nut
(drum) 3 clockwise until the gap a is within
the specified limits.
Gap
a
:
0 ~ 1 mm (0.00 ~ 0.04 in)
●
Checking the rear brake pedal free play to see
whether or not it is within the specified limits. If
not, perform the above steps again.
●
Turn the brake lever cable adjusting nut
(handlebar) 2 until the rear brake lever free
play b is within the specified limits.
●
Tighten the locknut (handlebar) 1.
●
Adjust the select lever control cable.
Refer to “ADJUSTING THE SELECT LEVER
CONTROL CABLE AND SHIFT ROD”.
WARNING
After this adjustment is performed, lift the
front and rear wheels off the ground by
placing a block under the engine, and spin
the rear wheels to ensure there is no brake
drag. If any brake drag is noticed perform
the above steps again.
*****************************************************
Rear brake pedal free play:
20 ~ 30 mm (0.8 ~ 1.2 in)
Rear brake lever free play:
3 ~ 5 mm (0.12 ~ 0.20 in)