Filter
Top Products
8 - 38
CHAS
●
Attach the assembled ball joint remover/
installer, new ball joint B and installer
attachment 8 to the steering knuckle C.
N
OTE:
Do not tap or damage the top of the ball joint.
●
Hold the body 3 in place while turning in the
long bolt 4 to install the new ball joint B into
the steering knuckle C.
●
Remove the ball joint remover/installer.
●
Apply lithium-soap base grease to the new
ball joint B.
●
Install a new rubber boot and new circlip.
N
OTE:
Always use a new ball joint set.
●
Install a steering knuckle oil seal.
*****************************************************
3.Check:
●
Front wheel bearings
Bearings allow play in the wheel hubs or the
wheel turns roughly → Replace.
●
Oil seals
Damage → Replace.
*****************************************************
Replacement steps:
●
Clean the outside of the steering knuckle.
●
Remove the oil seals 1.
●
Drive out the bearings 2.
WARNING
Eye protection is recommended when
using striking tools.
●
Remove the spacer 3.
●
Apply lithium base grease to the bearings
and oil seals.
●
Install the spacer to the steering knuckle.
STEERING SYSTEM