Filter
Top Products
9 - 12
– +
ELEC
IGNITION SYSTEM
C0NTINUITY
6.Ignition coil resistance
●
Disconnect the ignition coil connector from
the wire harness.
●
Connect the pocket tester (Ω × 1) to the
ignition coil.
Tester (+) lead
→
Orange lead terminal
Tester (–) lead
→
Ignition coil base
●
Check that the primary coil has the
specified resistance.
Primary coil resistance:
0.18 ~ 0.28
Ω
at 20 °C (68 °F)
*
OUT OF SPECIFICATION
Replace the ignition coil.
BOTH MEET
SPECIFICATION
●
Connect the pocket tester (Ω × 1k) to the
ignition coil.
Tester (+) lead
→
Orange lead terminal
Tester (–) lead
→
Spark plug lead
●
Check that the secondary coil has the
specified resistance.
Secondary coil resistance:
6.32 ~ 9.48 k
Ω
at 20 °C (68 °F)
CORRECT
7.Engine stop switch
Refer to “CHECKING THE SWITCHES”.
*
INCORRECT
Replace the handlebar switch (left).