Filter
Top Products
8 - 43
CHAS
*****************************************************
Replacement steps:
●
Clean the outside of the front lower arm.
●
Remove the circlip 1 and rubber boot 2.
Use the ball joint remover and installer set.
●
Install the body 3, long bolt 4, remover
washer 5 and remover spacer 6 onto ball
joint.
N
OTE:
Remover washer 5 must be aligned with the
projection on the head of the ball joint.
●
Hold the body 3 in place while turning in the
long bolt 4 to remove the ball joint 0 from
the front lower arm.
●
Remove the ball joint remover/installer.
Ball joint remover/installer set:
P/N. YM-01474/90890-01474
Ball joint remover/installer
attachment set:
P/N. YM-01477
3 Body
YM-01474
90890-01474
4 Long bolt
YM-01474
90890-01474
5 Remover washer YM-01477
6 Remover spacer YM-01477
7 Installer attachment YM-01477
8 Installer spacer YM-01477
9 Installer guide YM-01477
●
Install the long bolt 4, installer spacer 8
and installer guide 9 onto the body 3.
FRONT ARMS AND FRONT SHOCK ABSORBERS