Filter
Top Products
GEN
INFO
1 - 7
SPECIAL TOOLS
90890-04135
YM-04135
Sheave fixed block
This tool is needed when removing or
installing the secondary sheave
spring.
90890-01404
YM-01404
Flywheel puller
These tools are needed to remove
the rotor.
90890-01327
YM-01327
Damper rod holder (30 mm)
This tool is needed to loosen and
tighten the steering stem bearing
retainers.
90890-01426
YU-38411
Oil filter wrench
This tool is needed to loosen or
tighten the oil filter cartridge.
90890-01430
YM-38404
Ring nut wrench
This tool is needed to removing and
installing the middle driven shaft
bearing retainers.
90890-01467
YM-01467
90890-01475
YM-01475
Gear lash measurement tool
This tool is used to measure the gear
lash.
90890-01474
YM-01474
Ball joint remover/installer set
This tool is used to remove and install
the ball joints.
YM-01477
Ball joint remover/installer attachment
set
This tool is used to remove and install
the ball joints.
90890-01701
YS-01880-A
Sheave holder
This tool is needed to hold the
primary sheave when removing or
installing the sheave bolts.
Tool No. Tool name/How to use Illustration