Filter
Top Products
4 - 85
ENG
MIDDLE GEAR
●
Tighten the bearing retainer.
CAUTION:
The middle driven shaft bearing retainer
has left-handed threads. To tighten the
bearing retainer, turn it counterclockwise.
*****************************************************
3.Install:
●
Shims 1
●
Bearing housing
N
OTE:
Install the shims so that the tabs are positioned
as shown in the illustration.
T
R
.
.
Bearing retainer:
110 Nm (11.0 m • kg, 80 ft • lb)
4.Install:
●
Universal joint yoke (rear side)
●
Washer
●
Nut 1
N
OTE:
Use the universal joint holder 2 to hold the
yoke.
Universal joint holder:
P/N. YM-04062, 90890-04062
LT
T
R
.
.
97 Nm (9.7 m • kg, 70 ft • lb)
5.Install:
●
Universal joint
*****************************************************
Installation steps:
●
Install the opposite yoke into the U-joint.
●
Apply wheel bearing grease to the bearings.