Filter
Top Products
9 - 49
– +
ELEC
2WD/4WD SELECTING SYSTEM
EB803020
TROUBLESHOOTING
Procedure
Check:
1.Fuses (main, four-wheel drive)
2.Battery
3.Main switch
IF THE GEAR MOTOR FAILS TO OPERATE:
4.On-command four-wheel drive switch
5.Gear motor
6.Wiring connections
(the entire 2WD/4WD selecting system)
N
OTE:
●
Remove the following part(s) before
troubleshooting:
1)Seat
2)Front carrier
3)Front fender
●
Use the following special tool(s) for
troubleshooting.
Pocket tester:
P/N. YU-03112-C, 90890-03112
EB802011
CONTINUITY
1.Fuses (main, four-wheel drive)
Refer to “CHECKING THE SWITCHES”.
NO CONTINUITY
Replace the fuse.
EB802012
CORRECT
2.Battery
●
Check the battery condition.
Refer to “CHECKING THE BATTERY” in
CHAPTER 3.
Open-circuit voltage:
12.8 V or more at 20 °C (68 °F)
INCORRECT
●
Clean the battery terminals.
●
Recharge or replace the battery.
CORRECT
3.Main switch
Refer to “CHECKING THE SWITCHES”.
*
INCORRECT
Replace the main switch.