Filter
Top Products
3 - 48
CHK
ADJ
●
Measure the width È between the marks.
●
Rotate the front tires 180° until the marks are
exactly opposite one another.
●
Measure the width É between the marks.
●
Calculate the toe-in using the formula given
below.
●
If the toe-in is incorrect, adjust it.
*****************************************************
3.Adjust:
●
Toe-in
WARNING
●
Be sure that both tie-rods are turned the
same amount. If not, the machine will drift
right or left even though the handlebar is
positioned straight. This may lead to
mishandling and an accident.
●
After setting the toe-in to specification,
run the machine slowly for some distance
with both hands lightly holding the
handlebar and check that the handlebar
responds correctly. If not, turn either the
right or left tie-rod within the toe-in
specification.
*****************************************************
t
Adjustment steps:
●
Mark both tie-rods ends.
This reference point will be needed during
adjustment.
●
Loosen the locknuts (tie-rod end) 1 of both
tie-rods.
●
The same number of turns should be given
to both the right and left tie-rods 2 until the
specified toe-in is obtained. This is to keep
the length of the rods the same.
●
Tighten the rod end locknuts of both tie rods.
N
OTE:
Adjust the rod ends so that A and B are equal.
*****************************************************
Toe-in =
É
–
È
T
R
.
.
Locknut (rod end):
40 Nm (4.0 m • kg, 29 ft • lb)
ADJUSTING THE TOE-IN