Filter
Top Products
7 - 11
DRIV
FRONT CONSTANT VELOCITY JOINTS AND
DIFFERENTIAL GEAR
●
Install the dust boots.
●
Install the dust boot bands.
N
OTE:
●
The new boot bands may differ from the
original ones.
●
The dust boots should be fastened with the
dust boot bands 3 at the grooves in the joint
shaft.
*****************************************************
3.Check:
●
Free play (thrust movement)
Excessive play → Replace the joint
assembly.
ASSEMBLING THE DIFFERENTIAL GEAR
1.Measure:
●
Gear lash
Refer to “MEASURING AND ADJUSTING
THE DIFFERENTIAL GEAR LASH”.
2.Install:
●
Gear motor
*****************************************************
Servomotor installation steps:
●
Make sure that the gear motor and shift fork
sliding gear are in the 2WD position.
●
While aligning the gear motor stopper a with
the differential gear case boss b, mesh the
pinion gear (gear motor) and shift fork sliding
gear together.
●
Push the gear motor into the differential gear
case.
●
Rotate the gear motor counterclockwise until
it lines up with the gear motor mounting hole.
N
OTE:
When the gear motor is in this position, the
spring inside the gear motor has been
preloaded for positive engagement.
●
Install the gear motor bolts.
●
Fill the differential with the specified grade
and quantity of oil.
*****************************************************