Filter
Top Products
9 - 21
– +
ELEC
ELECTRIC STARTING SYSTEM
5.Measure:
●
Brush length a (each)
Out of specification → Replace the brush
holder set.
Brush length:
12.5 mm (0.49 in)
<Wear limit:>
5 mm (0.20 in)
6.Measure:
●
Brush spring force
Fatigue/out of specification → Replace the
brush holder set.
Brush spring force:
7.65 ~ 10.01 Nm
(780 ~ 1,020 g, 27.54 ~ 36.03 oz)
7.Check:
●
O-rings
Wear/damage → Replace.
ASSEMBLING THE STARTER MOTOR
1.Install:
●
Brush holder set 1
N
OTE:
Align the projection a on the brush seat 1 with
the slot b on the yoke.
2.Install:
●
Yoke
●
Brackets
N
OTE:
Align the match marks a on the yoke with the
match marks b on the brackets.