Filter
Top Products
7 - 29
DRIV
REAR AXLE/FINAL DRIVE GEAR AND DRIVE SHAFT
3.Apply:
●
Sealant (Quick Gasket
®
)
(to the mating surfaces of the swingarm and
the final drive gear case)
Sealant (Quick gasket
®
):
P/N. ACC-11001-05-01
Yamaha bond No.1215:
P/N. 90890-85505
4.Install:
●
Final drive gear
●
Nuts
●
Bolts
LT
T
R
.
.
63 Nm (6.3 m • kg, 45 ft • lb)
LT
T
R
.
.
63 Nm (6.3 m • kg, 45 ft • lb)
5.Install:
●
Dust cover
●
Rear axle
*****************************************************
Installation steps:
●
Install the dust cover 1 onto the rear axle.
N
OTE:
Adjust the length a to 210.1 mm (8.3 in) when
installing the dust cover.
●
Install the rear axle (with dust cover) 2.
●
Install the rear brake drum and rear wheel
hub (left).
●
Temporarily tighten the left axle nut 3.
N
OTE:
After tightening the rear axle nut 3, the
position of the dust cover 1 will slightly move
to protect the oil seal of the final gear case.
*****************************************************