Filter
Top Products
– 66 –
ENG
CRANKCASE
SEPARATING THE CRANKCASE
1.Separate:
●
Left crankcase
●
Right crankcase
*****************************************************
Separation steps:
●
Remove the crankcase bolts.
N
OTE:
●
Loosen each bolt 1/4 of a turn at a time and
after all the bolts are loosened, remove
them.
●
Loosen the bolts in stages, using a
crisscross pattern.
È
Left crankcase
É
Right crankcase
*****************************************************
È
É
ASSEMBLING THE CRANKCASE
1.Apply:
●
Sealant (Quick Gasket
®
) 1
(to the mating surfaces of both case halves)
2.Install:
●
Dowel pins 2
3.Fit the right crankcase onto the left case. Tap
lightly on the case with a soft hammer.
CAUTION:
Before installing and torquing the
crankcase holding bolts, be sure to check
whether the transmission is functioning
properly by manually rotating the shift
shaft in both directions.
Sealant (Quick Gasket
®
):
P/N. ACC-11001-05-01
Yamaha bond No. 1215:
P/N. 90890-85505