Filter
Top Products
ENGINE
3.20
ES50PL Adjusting Pad S election Matr ix
1. Measure valve clearance at TDC (Compression stroke) using thickness gauge with original adjusting pad installed.
2. Reference the measurement and the 3 digits marked on the existing adjusting pad on the matrix below
3. Select a suitable adjusting pad from the matrix below and replace existing pad
4. Measure and confirm that valve clearance is within the standard values
5. If valve clearance is not within standard, reverify step #1 and repeat procedures again
Example:
Intake -- Valve clearance before adjusting: 0.23mm (.009”)
Exsisting adjusting pad mark: 177
From “Intake Adjusting Pad Selection Matrix”, a suitable adjusting pad would be 185
Exhaust -- Valve clearance before adjusting: 0.35mm (.0137”)
Exsisting adjusting pad mark: 177
From “Exhaust Adjusting Pad Selection Matrix”, a suitable adjusting pad would be 185
Enfocus Software - Customer Support