Filter
Top Products
BODY / STEERING / SUSPENSION
5.6
9. Place a shop towel on hub to protect surface.
Carefully pry seal out of hub.
Seal
10. Using a brass drift, tap bearing spacer to one side
to expose inner bearing race. Drive bearing out
using a drift through opposite side of hub and
discard.
Tap spacer to side
11. Remove spacer. Drive other bearing out and
discard.
12. Clean hub and spacer thoroughly.
13. Inspect spacer for wear or damage. Measure the
tapered spacer for wear, replace as needed.
.774 r .005
.797 r .005
Tapered Spacer
FRONT HUB ASSEMBLY
1. Drive or press one new bearing into hub using a
bearing driver.
Hub
Seals (2)
Bearings (2)
Tapered Spacer
CAUTION: Do not drive on the inner race of the
bearing.
Premium All-Season Grease
(PN 2871322) (3 oz. T ube)
(PN 2871423) (14 oz. Tube)
2. Coat bearing spacer with grease and install into
hub. Drive or press the other bearing into hubuntil
seated against spacer.
3. Install seal into hub (with numbers facing out) until
flush with end of seal bore.
Seal
Enfocus Software - Customer Support