Filter
Top Products
1-73
Rev 2 Apr/2004 KMD 250 Pilot's Guide
Section 1
Basic Operation
4. The Direct-To will also be
denoted on the ACTIVE
FLIGHT PLAN Page. Press
the FPL Key and note the
change in the magenta arrow
in the waypoint list indicates a
Direct-To the waypoint as
shown in Figure 1-141.
After the waypoint is reached,
the KMD 250 will navigate the
remainder of the active flight
plan.
MANUALLY SELECTING AN
ACTIVE FLIGHT PLAN LEG
To select a specific leg within
an active flight plan perform the
following steps.
1. Press the Direct-To Key to
display the Direct-To window
as shown previously in Figure
1-139 .
2. Press the Direct-To Key a
second time to display Figure
1-142.
3. Use the Joystick to scan
the flight plan legs.
4. When the desired leg is
displayed, press the ACTI-
VATE Softkey and the Map will
again be displayed as in Figure
1-143. Note the airplane is
navigating to intercept the
selected flight plan leg.
After the leg is intercepted, the KMD 250 will provide navigation guid-
ance the remainder of the active flight plan.
Flight Plan Operation
Figure 1-142
Figure 1-143
Figure 1-141