Filter
Top Products
1-57
Rev 2 Apr/2004 KMD 250 Pilot's Guide
Section 1
Basic Operation
1. Select the destination as
discussed in the Direct-To pro-
cedure.
2. Press the OBS COURSE
Softkey shown in Figure 1-101.
This will display the OBS
COURSE window as shown in
Figure 1-102.
NOTE: Unless using OBS
Course Mode within an active
flight plan, Auto Leg
Sequencing (see Appendix A)
will be disabled.
3. The course field will be
highlighted. Use the Rotary
Knob to select the desired
OBS course. If desired, the
Joystick can be used to select
the destination identifier in
order to enter a new destina-
tion. Turn the Rotary Knob to
display the WAYPOINT
ENTRY window.
4. Press the ACTIVATE
Softkey and the route will be
displayed on the Map as
shown in Figure 1-103.
NOTE: When OBS Mode is
active, pressing the Direct-To
Key will display the active OBS
COURSE window.
To change the OBS course to
a Direct-To route press the the
Direct-To Key to display Figure 1-102. Press the DIR TO Softkey and a
Direct-To will be selected for the current identifier. Press the ACTIVATE
Softkey to enter and display the Direct-To route.
To center the CDI, from the OBS COURSE window (Figure 1-102) press
the DIR TO Softkey then press the OBS COURSE Softkey. The CDI will
now be centered.
Direct-To Operation
Figure 1-101
Figure 1-102
Figure 1-103