Filter
Top Products
8 - 43
–+
ELEC
SIGNALING SYSTEM
YES
NO
YES
NO
EAS00800
4. The neutral indicator light fails to come on.
YES
NO
YES
NO
• Set the main switch to “ON”.
• Set the turn signal switch to “ ” or “ ”.
• Measure the voltage (12 V) on brown/white
1 at the turn signal relay coupler.
• Is the voltage within specification?
The turn signal relay
is faulty and must be
replaced.
5. Voltage
• Connect the pocket tester (DC 20 V) to the
front turn signal light connectors (wire har-
ness side), tail light assembly coupler (wire
harness side) or meter assembly coupler as
shown.
È
Front turn signal light
É
Rear turn signal light
Ê
Turn signal indicator light
Left turn signal light
Tester positive probe
→
chocolate
1
Tester negative probe
→
ground
Right turn signal light
Tester positive probe
→
dark green
2
Tester negative probe
→
ground
Ch Dg
Ch
Dg
Ch B
Y
L/R
Dg Y L
B
R/W
G/WY/L
Lg
Y
Ch
Dg
L
R/G
B/W
Br/R
W
• Set the main switch to “ON”.
• Set the turn signal switch to “ ” or “ ”.
• Measure the voltage (12 V) of the chocolate
1 or dark green 2.
• Is the voltage within specification?
This circuit is OK. The wiring circuit
from the turn signal
switch to the front
turn signal light con-
nectors (wire harness
side), tail light
assembly coupler
(wire harness side)
or meter assembly
coupler is faulty and
must be repaired.
1. Neutral indicator light bulb and socket
• Check the neutral indicator light bulb and
socket for continuity.
• Are the neutral indicator light bulb and
socket OK?
Replace the neutral
indicator light bulb,
socket or both.
2. Neutral switch
• Check the neutral switch for continuity.
Refer to “CHECKING THE SWITCHES”.
• Is the neutral switch OK?
Replace the neutral
switch.
È
É
Ê