Filter
Top Products
5 - 21
ENG
CYLINDER HEAD
d. Place a 400 ~ 600 grit wet sandpaper on
the surface plate and resurface the cylinder
head using a figure-eight sanding pattern.
NOTE:
@
To ensure an even surface, rotate the cylinder
head several times.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
EAS00232
INSTALLING THE CYLINDER HEAD
1. Install:
• dowel pins 1
• gasket 2
New
2. Install:
• cylinder head
NOTE:
@
Pass the timing chain through the timing chain
cavity.
3. Tighten:
• cylinder head bolts (M10) 1
NOTE:
• Do not reuse the cylinder head bolts.
• The tightening procedure of the cylinder
head bolts is angle controlled, therefore
tighten the bolts using the following proce-
dure.
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Lubricate the cylinder head bolts and wash-
ers with engine oil.
b. Install the washers and cylinder head bolts.
c. Tighten the cylinder head bolts in the proper
tightening sequence as shown.
T
R
.
.
Cylinder head bolt (M10)
1st
25 Nm (2.5 m · kg)
New