Filter
Top Products
7 - 6
FI
FUEL INJECTION SYSTEM
* Table of self-diagnostic fault code numbers displayed on meter
• How to erase the self-diagnostic fault code from memory:
If the ECU detects a normal signal upon the completion of the repair of the malfunction, the self-
diagnostic fault code disappears from the meter and is replaced by the normal clock display. How-
ever, the self-diagnostic fault code of the previous malfunction remains in the ECU memory as
part of the malfunction history. To erase the self-diagnostic fault code from the malfunction history,
the operation for diagnostic code 62 must be performed in the diagnosis mode.
No. Symptom
Able/
unable to
start
Able/
unable to
drive
No. Symptom
Able/
unable to
start
Able/
unable to
drive
11
No normal signals are received
from the cylinder identification
sensor.
Able Able 30
The motorcycle has overturned.
Unable Unable
12
No normal signals are received
from the crankshaft position sen-
sor.
Unable Unable 31
The amount of air-fuel ratio feed-
back compensation is maintained
continuously in the vicinity of the
upper limit (lean air-fuel ratio).
Able Able
13
Intake air pressure sensor - open
or short circuit detected.
Able Able 32
The amount of air-fuel ratio feed-
back compensation is maintained
continuously in the vicinity of the
lower limit (rich air-fuel ratio).
Able Able
14
Faulty intake air pressure sensor
pipe system; a hose is detached,
causing the constant application
of atmospheric pressure to the
sensor; or, the hose is clogged.
Able Able 33
Open circuit detected in the pri-
mary wire of the ignition coil
(#1,4). Able Able
15
Throttle position sensor - open or
short circuit detected.
Able Able 34
Open circuit detected in the pri-
mary wire of the ignition coil (#2, 3).
Able Able
16
A stuck throttle position sensor is
detected.
Able Able 41
Lean angle cut-off switch - open
or short circuit detected.
Unable Unable
19
Open circuit is detected in the
input line from the sidestand
switch to the ECU.
Unable Unable 42
No normal signals are received
from the speed sensor; or, an
open or short circuit is detected in
the neutral switch.
Able Able
21
Coolant temperature sensor -
open or short circuit detected. Able Able 43
The ECU is unable to monitor the
battery voltage (an open circuit in
the line to the ECU).
Able Able
22
Intake temperature sensor - open
or short circuit detected. Able Able 44
An error is detected while reading
or writing on EEPROM (CO
adjustment value).
Able Able
23
Atmospheric pressure sensor -
open or short circuit detected.
Able Able
50
Faulty ECU memory. When this
malfunction is detected, the code
number might not appear on the
meter.
Unable Unable
24
No normal signals are received
from the O
2
sensor.
Able Able