4 - 51
CHAS
EAS00309
EAS00310
ASSEMBLING AND INSTALLING THE
CLUTCH MASTER CYLINDER
WARNING
@
• Before installation, all internal clutch
components must be cleaned and lubri-
cated with clean or new clutch fluid.
• Never use solvents on internal clutch
components as they will cause the piston
seals to swell and distort.
Recommended clutch fluid
Brake fluid DOT 4
1. Install:
• clutch master cylinder
1
NOTE:
@
• Install the clutch master cylinder holder with
the “UP” mark facing up.
• Align the end of the clutch master cylinder
holder with the punch mark
a
in the left han-
dlebar.
• First, tighten the upper bolt, then the lower
bolt.
T
R
.
.
10 Nm (1.0 m · kg)
2. Install:
• copper washers
1
• clutch hose
2
• union bolt
3
WARNING
@
Proper clutch hose routing is essential to
insure safe motorcycle operation. Refer to
“CABLE ROUTING”.
New
T
R
.
.
30 Nm (3.0 m · kg)
HYDRAULIC CLUTCH